Model 50 Heater core leg show Please note that we offer

Please note that we offer higher fin density

When we manufacture a pressurized model A we integrate the tabs into the return flange of the sidewall and utilize riv-nut fittings

We require a pattern or a drawing to construct this heater core

The COE and 1-1/2T HD with the 3" Harrison V Cell film core had a water passage of 2-1/2" with 1/4" lead dip on the face and rear and we replace this with a 2-5/8" 10FPI tube and fin core

75" wide x 2

Model 50 Heater core leg show Please note that we offerModel 50 Pattern required Made in the USA Each heater core is made to order, please allow adequate time for us to fabricate. Present Lead times.