Kta kbt40 er32 Holder Er32/70/100 Collet Chuck Holder dasqua height checking equipment ER32 Wrench works on all

ER32 Wrench works on all of our UM Type and UM type collet chucks that take ER32 collets

20 microns per division radially

Overall length : 15-1/4"( 385mm )

Each ER20 collet has a range of (1 mm)

you can use SOMT12T3 Of Mitsubishi and Tabikut Brand Insert into this

Kta kbt40 er32 Holder Er32/70/100 Collet Chuck Holder dasqua height checking equipment ER32 Wrench works on allBBT40 Holder Taper and Both Faces Are in Contact With the Spindle. As a result, the spindle and Holder Act as a single unit. This allows for a Higher "Radial Rigidity", Hence We Get Good Surface Finish and Dimensional Accuracy While Machining Also Low Vibration at higher speeds, which increases tool life. So These Are Better Than General Bbt40 Holders, but they should only be used with BBT40 calibrated spindles. Collet Chuck Holder Is Balanced to G2.