Heater Hose to Cylinder Head Fitting - Fits 1965-1971 Tri-power Engine Compartment It incorporates the mandatory steel

It incorporates the mandatory steel sleeve and pressure release bypass found in factory-orginal housings for long lasting strength

The 1966 tripower used 2 of the 105 degree fittings center and rear carb

I have a new set of blackened screws and washers you can add to the rebuild kit at a savings or buy separately on the page

This kit includes everything needed other than the chrome wing nuts set of three $5

If your J-bar is missing or damaged this is what you need

Heater Hose to Cylinder Head Fitting - Fits 1965-1971 Tri-power Engine Compartment It incorporates the mandatory steel1965 1971 Heater Hose Nipple. This is a great reproduction of this clever fitting that the auto industry industry designed using a flat coil spring as a water flow valve. This coil regulates large fluctuations in flow ( maintains 5 6 gallons minute) and is compatible with stamped impellers, cast impellers, high volume pumps, and street strip performance pumps.